- This topic has 0 replies, 1 voice, and was last updated 4 months ago by
Kazuma.
Viewing 0 reply threads
-
Posts
-
-
Kazuma
A basic question, but …
just to be on a safe side, in a typical scenatio, given a widely used stock schematic, where XTAL is connected alongside with two capacitors (see pic),
how does one properly replace stock XTAL, and where & howto inject our upgraded low noise signal our oscillator? (for example using Pierce pico gate oscillator)
Step 1: desolder old XTAL
Step 2:…
Can you write up some simple gerenal instruction, please?
If we need to remove old capacitors also, check signal levels with oscilloscope, add resistors anywhere etc.
Maybe in P.S. throw in some ‘nice to have’ advices, that are not mandatory, but would improve signal integrity, like adding shunts etc. etc.
-
Viewing 0 reply threads
- You must be logged in to reply to this topic.