nguyen phuong
Hi, there may be somethings wrong when I connect ERED-DOCK I2S out to I2S in port 1 on FIFO.
So, I need your help.
Which signal from I2S out (off Ered Dock) to I2S in Port 1 (in FIFO lite)
https://www.engineered.ch/products/ered-dock/
1= GND = Ground for I/O and clock management.
2 = MCLK = Master Clock Output – Master clock output at 22.5792MHz or 24.576MHz.
3 = GND = Ground for I/O and clock management.
4 = SPDIF = S/PDIF Output – Serial encoded PCM audio data stream, TTL level.
5 = GND = Ground for I/O and clock management.
6 = BCLK = Serial Audio Bit Clock Output – Serial bit clock for PCM and DSD audio data.
7 = GND = Ground for I/O and clock management.
8 = PCM_LRCLK =Serial Audio Left/Right Clock Output – Frame sync clock for PCM audio data.
9 = GND = Ground for I/O and clock management.
10 = PCM_SDATA1 = /DSDR = Serial Audio Data DSD right-channelOutput audio data.
11 = GND = Ground for I/O and clock management.
12 = PCM_SDATA0 = /DSDL Serial Audio Data Output Stereo PCM audio data / DSD left-channel audio data.
13 = GND = Ground for I/O and clock management.
14 = MUTE # Mute signal
Low: the audio data stream is not valid and the DAC must be muted.
High: the audio data stream is valid.
15 = DSD_PCM# = Audio Stream Format
Low: the digital audio output stream format is PCM.
High: the digital audio output stream format is DSD.
16 = 44K1_EN# Sampling Frequency
Low: the sampling frequency is a multiple of 44.1kHz.
High: the sampling frequency is a multiple of 48kHz. Refer to Table 4-1.
17 = RATE0 = Sampling Rate – Sampling rate information. Refer to Table 4-1.
18 = RATE1 = Sampling Rate – Sampling rate information. Refer to Table 4-1.
19 = reserved = Unused. Do not connect.
20 = GND = Ground for I/O and clock management
The attachment is the Í2S signal out from ered dock
Please help me: Which signal from I2S out (off Ered Dock) to I2S in Port 1 (in FIFO lite)
Tks
Phương